Installing Or Removing A Flash Memory Or Firmware Card - Ricoh InfoPrint 1650 User Manual

Installing or removing a flash memory or firmware card

Installation
Note: Flash memory or firmware cards designed for other MFPs may not work with this
MFP.
1
Remove the system board access cover. (See
Note: If an option card has been installed, you may need to remove the option card before
installing the flash memory or firmware card.
2
Unpack the flash memory or firmware card.
3
Holding the flash memory or firmware card by the locking clips, align the plastic pins on the
card with the holes on the system board.
4
Push the flash memory or firmware card firmly into place, and release the locking clips.
The entire length of the connector on the flash memory or firmware card must touch the
system board and be locked into the connector.
Be careful not to damage the connectors.
Flash memory or firmware card
Connector
Accessing the MFP system
117
board.)