Replacing The Burner Parts - Fisher & Paykel OR30SDG6 User Manual

Burner parts
—
You can remove and clean these parts with hot soapy water or non-abrasive
detergents. Clean spills regularly before they become burnt on. Do not wash these
parts in a dishwasher.
—
After cleaning, check that the burners and their flame spreaders are dry before
replacing correctly.
—
It is very important to check that the burner flame spreader and the cap have been
correctly positioned. Failure to do so can cause serious problems.
— Check that the ignitor is always clean to ensure trouble free sparking. It must be
cleaned very carefully using a toothbrush and methylated spirits.
— Note: to avoid damage to the electronic ignition, do not try to light a burner without
all burner parts in place.

Replacing the burner parts

—
Carefully replace the burner parts as per the following illustrations.
—
Fit the flame spreader to the housing as shown below. Make sure the burner is not able
to rotate.
Check that:
— the ignitor is always clean to ensure trouble-free sparking
— the probe is always clean to ensure correct operation of the safety valves
— the flame spreaders are clean and the holes are not clogged
Note: both the ignitor and probe must be very carefully cleaned using a toothbrush
and methylated spirits.
Replacing the semi-rapid burners
C
Cap
F
Flame
spreader
Correct positioning of semi-rapid burner parts
52
CARE AND CLEANING
S
Ignitor
Replacing the semi-rapid burner caps