Setting Display Positions Of Camera Images - Eizo DuraVision FDF2304W-IP Installation Manual

2-4. Setting Display Positions of Camera Images

Set the display position for images from the network camera.
Procedure
1. Select "Position".
1
2. Configure the items.
Item
Position
Camera Name Display
Sequence Interval
Aspect Ratio Mode
3. Select "Apply".
The setting complete screen is displayed. Select "OK".
Attention
• All registered network cameras must be configured. A network camera can only be set for one display position.
When there are incorrect settings, "Apply" cannot be selected.
• When displaying the image layout in three screens
- Only the Axis network camera displays portrait images maintaining their vertical and horizontal image aspect
ratios. To display images, the network camera setting is required. For details on the settings, refer to the
network camera User's Manual.
Note
• If it takes a while for images to be displayed during sequential display, set a higher value for "Sequence Interval".
22
Chapter 2 Configuring from the monitor screen
2
3
Select a position to display a camera image.
Set the network camera to the number of the
desired position for display.
Select to display or not display the camera name
and time set on the monitor. (The camera name is
displayed on the upper left of the image.)
Set the interval for changing over the screen during
sequential display.
Set which aspect ratio to apply when the aspect
ratio of the video delivered from the network
camera and the aspect ratio of the monitor image
display area differ.
Detail
Indicates the
display positions
on the monitor
screen.
Setting range
-
On / Off
5s to 60s
Full / Aspect