Hongqi HS7 Manual page 163

NOTICES
■If SACC is activated, when your vehicle is too close to the preceding vehicle
(for example, due to emergency braking of the preceding vehicle), the system
will send a sound and lamp alarm message to you through the combination
instrument. As a result, you should pay attention to the inter-vehicle distance
and control your vehicle.
■During SACC cruise control, when the steering wheel is shaken or rotated
too fast, the system will give an audible and visual alarm to the driver on the
dashboard; at this time, the driver should pay attention to the road conditions
and take over the vehicle control.
■SACC will maintain the preset distance to follow the target object. SACC will
automatically stop the vehicle if the target vehicle decelerates or stops.
■The vehicle will automatically start under the control of SACC if the target
vehicle restarts or leaves the lane within 3s after stopping.
■If the target vehicle restarts or leaves the lane after 3s yet within 3 min after
stopping, the combination instrument MFD will remind the driver to resume
cruise. The driver can gently depress the accelerator pedal or pull cruise
control lever to RES+ to resume SACC function, so as to achieve the vehicle
automatic starting.
■SACC will automatically be canceled if the vehicle stops for over 3 min.
■The SACC cannot stop your vehicle for a long time. Do not leave your vehicle
while the ACC keeps the vehicle stopped. Be sure to shift the selector lever in
the P position before leaving your vehicle.
■Observe the following precautions when cornering with the SACC activated:
●.In.a.sharp.corner,.the.SACC.may.be.canceled.or.limit.the.vehicle.speed.
●On a curve, the SACC may respond to the vehicle in another lane or may not have
time.to.respond.to.the.vehicle.in.the.same.lane..Your.vehicle.may.collide.with.the.
preceding.vehicle.or.may.be.uncontrolled..Especially.when.driving.in.a.ramp,.the.
vehicle may be accelerated since the system loses its target due to an excessive
curve..Exercise.extreme.caution.on.a.curve.and.get.ready.to.apply.the.brakes.if.
necessary..When.driving.on.a.curve
●When.driving.on.a.curve,.choose.the.right.vehicle.speed.
●In.the.curve.course,.too.small.road.radius.may.impact.the.judgment.of.SACC.over.
the.lane..Take.care.when.driving.in.a.curve.
■ When your vehicle follows the preceding vehicle to pass through the
intersection with traffic lamps, observe the change of the traffic lamps and
intervene actively if necessary to avoid violating the traffic rules.
■When driving in heavy fog, rain, snow or other weather conditions, or there
is frost and/or dirty trace in the camera window area of the advanced driver
assistance system, or when your vehicle is moving in the direction toward
the sun (or strong light source), the "the camera of the advanced driver
assistance system has been blocked, please clean the windshield" prompt
may appear on the combination instrument due to limited visual field of the
camera. As a result, the SACC cannot work.
■When there is a risk of collision with the front vehicle determined by ACC,
there will be a corresponding alarm sound and "Warning! Please take the
initiative to drive the vehicle!" display on the dashboard; in this case, the
driver should take over the vehicle in time.
4-5..Using.Other.Driving.Systems
4
161