Hongqi HS7 Manual page 155

CAUTIONS
■It is normal that the cruise speed icon displayed on the combination
instrument multifunction display (MFD) flashes when the driver depresses the
accelerator pedal.
■ACC may lose or misrecognize the target vehicle when the vehicle is in bends,
lane-changing or when the front vehicle stops.
■Exercise greater caution to drive since the ACC cannot detect other sides,
children, pedestrians, animals or other objects but rear of the vehicle or apply
the brakes.
■Due to the ACC's limited braking capacity, there may be no time to
deaccelerate to avoid collision with the preceding vehicle. This may happen
when the preceding vehicle suddenly slows down, stops or enters your lane.
In case of danger, press the brake pedal for braking actively.
■Focus all of your attention on driving and get ready to take actions and to
apply the brakes.
■You need to adjust the safe interval and set the ACC system reasonably
according to the front traffic volume and the current weather conditions
(e.g., rain and snow). Whenever, you need to ensure that your vehicle can be
decelerated to standstill within your field of vision.
■ACC can only identify the motor vehicles (such as cars and trucks) that are
installed with legal license plates and allowed to travel on highways. If the
preceding vehicle is irregular in shape, modified and/ or covered by painting,
it may not be identified by the ACC, and the pedestrians and narrow vehicles
(such as bicycles and motorcycles) may not be identified, either. In this case,
you should get ready to control your vehicle according to the actual situation.
■The ACC system cannot accurately determine the width of the front lane
that can be passed. Therefore, when the lane in front of your vehicle's
moving direction becomes narrow and you feel your vehicle cannot pass it
normally, you should deactivate the ACC system immediately through braking
intervention and control the vehicle by yourself.
■Do not activate ACC on a long steep slope. ACC may not detect the preceding
vehicle in the same lane on a long steep slope. You usually need to control the
acceleration and braking of your vehicle by yourself on a long steep slope. If
the brakes are applied, ACC is canceled.
■The preceding vehicle icon on the combination instrument will be displayed
if the vehicle travelling in the same direction on the same lane is detected.
If the icon display does not match the actually observed situation, you are
responsible for controlling your vehicle and driving it based on the actual
situation.
■If you rest your foot on the accelerator pedal, ACC may not automatically
apply the brakes, resulting in a collision with the preceding vehicle. In this
case, exercise extreme caution.
■If a vehicle in the adjacent lanes enters the front of the direction in which your
vehicle moving but it is not covered by the sensor monitoring area, the sensor
may not detect it, resulting in sluggish response of ACC. Pay close attention
to the vehicle movement in the adjacent lanes. Control your vehicle actively if
necessary.
■If the preceding vehicle's brakes are applied suddenly (emergency stop), the
ACC may not respond at all or may respond slowly to the preceding vehicle,
resulting in a risk of late braking. In this case, you may not receive a request
of controlling your vehicle. Exercise extreme caution and control your vehicle
actively if necessary.
4-5..Using.Other.Driving.Systems
4
153