Table of Contents
Advertisement
Products Manual
NRD-1300,1600
5. Transportation and Installation of Product
5-1. Transportation and Unloading Method of Product
◆
Machine Unloading Method
During movement, transportation and unloading of
this machine, please put down the arm to the lowest
level, the spindle box at
table at position
ⓐ
the end of the T groove, and fixate the spindle box,
arm, and column sleeve completely.
Please
adjust
a
strong
instrument to the center of the machine as shown in
the following picture and use protection pads like a
thick fabric to prevent the rope from directly touching
the slideway face of the arm. Before lifting up the
machine, please recheck the centers of the rope and
machine.
◆
Transportation Method of Machine
During transportation of the machine, please adjust
the center equivalent to the unloading method, fixate
the arm and column sleeve firmly, use protection
pads like a thick fabric to protect the machine as
shown in the picture with strong enough rope, and
fixate the machine firmly as shown in numbers 1, 2,
3, and 4 in the picture to transport.
ⓐ
NRD-1300
250
NRD-1600
300
Please make sure to inquire or request us in advance during transportation and installation.
5-2. Wiring
Please connect the power R.S.T. to the power
terminal. If the power is input and the "ON"
switch on the front face of the machine is
pressed, a Pilot Lamp will light up.
If the lamp is not lit, please connect by
switching two of the three lines.
Please make sure to ground to the earth at the
ground mount.
16
Nambuk Co., Ltd.
position
ⓑ
, the working
, adjust
ⓔ
zig at
ⓒ ⓕ
,
enough
rope
Unit : mm
ⓑ
500
600
zig at
or
other
ⓒ
100
100
NB19-E01
Advertisement
Table of Contents
