SFS 7024 Leaf and Spine Module LEDs
Leaf Module IB Port LEDs
Each SFS 7024 leaf module port has a
•
•
•
•
Spine and Leaf Module Status LED
The status LED indicates one of the following conditions:
•
•
•
•
Spine and Leaf Module Attention LED
The Attention LED indicates one of the following conditions:
•
•
•
Spine Module Management LEDs
Each SFS 7024 spine module has three management LEDs:
•
•
Cisco SFS 7024 InfiniBand Server Switch Hardware Users Guide
36
AC OK
Amber
indicates that AC power is normal.
–
Off indicates a AC power failure or no AC power is present.
–
On - the logical link is up (port is in the Active state).
Slow Blink - the physical link is up (port is in the Initialization state).
Fast Blink - IB data is flowing through the port.
Off - the physical link is down (port is in the Down state).
Steady
Green
- the module is operating normally.
Blinking
Green
(twice per second) - transitioning to the removal state.
Blinking
Green
(once every four seconds) - LED test state.
Off - module is in the removable state.
Off - the system functioning normally.
Steady
Amber
- the system requires some attention, which could indicate one of the following
conditions:
The switch temperature is at a warning level on the module.
–
The switch silicon temperature is at a warning level (approximately 90 degrees C).
–
DC voltages on the board are slightly out of tolerance (12V Bulk, 5V, 3.3V, 1.8V, VBIO are all
–
monitored).
The module can no longer function properly. The system will take the appropriate actions to
–
ensure that no damage is done to its components.
Blinking
Amber
(once every four seconds) - LED test state.
Capable:
Green
indicates that the spine slot supports management.
–
Off indicates that the spine slot does not support management.
–
Stat:
Blue
IB link status LED that provide the following indications:
Chapter
OL-8794-04