Cisco SFS 7024 Hardware User's Manual page 78

Figure 3-32 SNMP Target Configuration Window
The top section of the window, SNMP Target Addresses, allows the user to determine what type of
SNMP traps are sent, and where they are sent. The rows provide an area for specifying multiple trap
destinations. The bottom section of the window, SNMP Target Parameters, allows the user to configure
each trap destination with version, optional security information, and filtering mechanisms.
The Apply button applies the current settings to either the SNMP Target Addresses or SNMP Target
Parameters section.
Note
Target Configuration Window Field Descriptions
The following are descriptions for each field in the Target MIB Configuration window:
SNMP Target Addresses:
•
•
•
Cisco SFS 7024 InfiniBand Server Switch Hardware Users Guide
60
The Target Configuration window is used for viewing and modifying existing SNMP target
entries. It is not used for creating new target entries.
To create a new target entry, use the following CLI command:
snmpTargetAddr add -n name -a addr
tag_list] [-v parameters] [-s storage_type]
For example:
To add a trap target with the IP address 192.168.0.123 that accepts SNMP v2c style traps:
snmpTargetAddr add -n traphost1 -a 192.168.0.123 -p "v2 params"
Or, to add the same target except using SNMP v1traps:
snmpTargetAddr add -n traphost1 -a 192.168.0.123 -p "v1 params"
Address Name
Specifies a unique, administrator-defined name the system uses to identify a row.
Transport Domain
Specifies the transport type of the address contained in the snmpTargetAddrTAddress object.
Transport Address
Specifies the IP address and port in hex, separated by colons. The first eight values make up the IP
address, the last 4 make up the port number. For example, specify 0xc0:a8:00:65:00:a2 for
192.168.0.101 Port: 162.
[-p port] [-t timeout] [-r retry_count] [-l
Chapter
OL-8794-04