Updating Management Spine Ip Addresses In A Redundant Management Configuration - Cisco SFS 7024 Hardware User's Manual

Chapter
Power up the SFS 7024.
Step 2
If using the RS-232 port, skip to Step 6. Steps 3 through 5 are for those users accessing the SFS 7024
Note
via Telnet or SSH.
If using Telnet or SSH, access the SFS 7024 with the following command:
Step 3
Step 4 The system prompts for a user name. In order to change the IP address and default gateway, the user must
be logged in as the administrator. At the prompt enter:
The system prompts for a password. At the prompt enter:
Step 5
The system responds with:
To change the SFS 7024 default IP address enter:
Step 6
where -h ipaddress is the new IP address in dotted decimal (i.e., xxx.xxx.xxx.xxx) format, and -m
netMask is the new subnet mask in dotted decimal (i.e., xxx.xxx.xxx.xxx) format.
To change the SFS 7024 default gateway IP address enter:
Step 7
where -h ipaddress is the new default gateway IP address in dotted decimal (i.e., xxx.xxx.xxx.xxx)
format.
To to exit the CLI enter:
Step 8

Updating Management Spine IP Addresses in a Redundant Management Configuration

This procedure should be performed the first time the SFS 7024 is powered on. Additionally, it is
Note
recommended to change the managed spine IP address for all available images (i.e., Image 1 and Image
2) when performing this procedure.
Each managed spine must have a unique IP address that is different than the chassis IP address of the
SFS 7024. Therefore, a redundantly-managed SFS 7024 will have six (6) unique IP addresses; three (3)
for each hemisphere. The current default IP addresses are:
OL-8794-04
– 56K baud
Use VT100 emulation.
–
Flow control = XON/XOFF
–
open 192.168.100.9
admin
adminpass
Welcome to the SFS 7024 CLI. Type 'list' for the list of commands.
setChassisIpAddr -h ipaddress -m netMask
setDefaultRoute -h ipaddress
logout
Lower Hemisphere
Chassis: 192.168.0.9
–
Spine 1: 192.168.0.11
–
– Spine 2: 192.168.0.12
Upper Hemisphere
– Chassis: 192.168.0.10
Cisco SFS 7024 InfiniBand Server Switch Hardware Users Guide
31