Table of Contents
Advertisement
Figure 2-12 SFS 7024 Chassis — Leaf Module Slot Numbering
To install a module or filler, hold it so that the ejector handles are on the bottom.
Step 2
Pull the handles out to extend them. Slide the module into the appropriate slot of the chassis until it
Step 3
makes contact with the backplane. As the module seats in the chassis, the handles will begin to close.
Push the handles in to fully close.
Step 4
Be sure that all cards are fully inserted in their respective chassis slots, and that the handles are in the
Note
locked position. This prevents accidental removal, provides proper grounding for the system, and helps
to seat the bus connectors in the backplane receptacles.
Removing a Module or Blank
The handles are self-locking. To unlock, push up on the handles to disengage from the lock notch. Then
gently pull the handles out and slide the module out of the slot.
If removing, but not replacing a module, remember to replace with a module blank. All slots must be
Note
either populated with a module or have blanks for EMI and thermal integrity.
Cisco SFS 7024 InfiniBand Server Switch Hardware Users Guide
26
Leaf 23
Leaf 24
Leaf 22
Leaf 21
Leaf 19
Leaf 20
Leaf 17
Leaf 18
Leaf 16
Leaf 15
Leaf 13
Leaf 14
Leaf 11
Leaf 12
Leaf 10
Leaf 9
Leaf 7
Leaf 8
Leaf 5
Leaf 6
Leaf 3
Leaf 4
Leaf 1
Leaf 2
Chapter
OL-8794-04
Advertisement
Table of Contents
