Cisco SFS 7024 Hardware User's Manual page 50

Cisco systems infiniband server switch users guide
Table of Contents

Advertisement

It is necessary for each managed spine to have a unique IP address for the following reasons:
Unique IP addresses are used when sending syslog messages from a managed spine to a syslog
server.
Gives the user the ability to ping each management spine separately.
If the IP addresses are not unique, collisions will occur, causing IP operations to fail.
To update the IP address on managed spine, do the following:
Step 1
Ensure that the spine module is connected to a COM port on a serial terminal device via the RS-232 port.
Step 2
Get to a [boot]: prompt by following Step a or b.
If the managed spine is running, enter the following command at the console:
a.
Then press Enter.
b.
If the managed spine is not running, power on the switch.
After selecting image1 or image2, press the Spacebar to interrupt the auto load sequence before the
Step 3
counter expires (within 5 seconds).
At the [boot]: prompt enter the new spine IP address with the following syntax:
Step 4
spineip <NEW IP ADDRESS>
Then press Enter.
At the [boot]: prompt, enter reboot, and press Enter. Upon reboot the managed spine will display
Step 5
information similar to the following:
Unified Boot Manager For The T3 Platform.
Image Date:
Checking L2 functionality...
BCM1125
L2 caches initialized and invalidated
CPU0 caches initialized
Initialized SMBUS Channels
SPD Checksum ok.
MEM_SEL = 0x00000007
CPU_REV = 0x00000001_112421FF
CPU speed = 400 MHz
IO Bridge 0,1 speed = 133, 200 MHz
Memory size = 128 MB
MC1 Configured for 128M SODIMM, CAS=2, 100 MHz
Configured Memory Size = 0x08000000
Channel Interleave Bit = 0
Number of Mem Channels = 1
Testing memory
Memory tests pass
CPU0 flushing caches
L2 flush complete
Start type = 0xBFC006A0
Jumping to romStart
Initializing HyperTransport bus
HyperTransport initialization completed
rintf MBOX connect interrupt_source=28 vector=62 status=0
Printf MBOX intEnable status=0
Found Intel Strata Flash 128 MBit (0x8918).
Mounted raw file system on device /image1. (size=6291456 bytes)
Mounted raw file system on device /image2. (size=6291456 bytes)
Cisco SFS 7024 InfiniBand Server Switch Hardware Users Guide
32
Spine 5: 192.168.0.13
Spine 6: 192.168.0.14
reboot
Jan 19 2006, 15:03:31
Chapter
OL-8794-04

Advertisement

Table of Contents
loading

Table of Contents