Fisher & Paykel DCS RGV2 User Manual page 49

Professional
Table of Contents

Advertisement

When a CLEAN cycle has finished
Once the oven has cooled to a cooking temperature,
the halos around the function and temperature knobs
will go out and the door will unlock.
You need to:
1 Turn the oven mode and temperature knobs
clockwise to OFF.
This will re-enable the grill or griddle, and the
secondary oven (48" models only).
You may continue to hear the noise of the cooling
fan: it is normal for the fan to stay on.
IMPORTANT!
Do not turn the power supply to the range off at the circuit breaker panel. The cooling
fan is needed to cool the oven. Disconnecting the range from the power supply while
the oven is too hot may damage the oven and its surrounding cabinetry.
2 Wait until the oven door automatically unlocks.
3 After the door has unlocked, wait for the oven to cool down completely.
IMPORTANT!
The oven will still be at cooking temperatures when the door unlocks. Take care.
4 Remove any gray ash from the oven with a small brush or damp cloth.
5 Wipe out the oven with a clean, damp cloth and dry with a clean, lint-free cloth.
6 Replace the side racks and shelves. See sections 'Removing and replacing the side racks'
and 'Positioning the shelves' for instructions.
To cancel a CLEAN cycle
1 Turn the oven mode and temperature knobs clockwise to OFF.
The halos will remain red.
The door will remain locked. Once the oven has cooled to a cooking temperature (this
may take up to 30 minutes, depending on the stage the cycle was in when canceled),
the halos around the function and temperature knobs will go out and the door will
unlock.
This will re-enable the grill or griddle, and the secondary oven (48" models only).
You may continue to hear the noise of the cooling fan: it is normal for the fan to stay on.
IMPORTANT!
Do not turn the power supply to the range off at the circuit breaker panel. The cooling
fan is needed to cool the oven. Disconnecting the range from the power supply while
the oven is too hot may damage the oven and its surrounding cabinetry.
2 Wait until the oven door automatically unlocks (up to 30 minutes).
3 After the door has unlocked, wait for the oven to cool down completely.
IMPORTANT!
The oven will still be at cooking temperatures when the door unlocks. Take care.
4 If necessary, wipe up any food soiling inside the oven.
We do not recommend cancelling a CLEAN cycle and then immediately starting one
again.
CARE AND CLEANING
47

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dcs rdv2Dcs rgcv2Dcs rgv2364gdnDcs rgv2364gdl

Table of Contents