Fcc Class B Compliance - Cisco Network Analysis Module 6000 Installation And Configuration Manual

Standards Compliance Specifications
THE ENTIRE RISK AS TO THE QUALITY AND PERFORMANCE OF THE PROGRAM IS WITH
YOU. SHOULD THE PROGRAM PROVE DEFECTIVE, YOU ASSUME THE COST OF ALL
NECESSARY SERVICING, REPAIR OR CORRECTION.
12. IN NO EVENT UNLESS REQUIRED BY APPLICABLE LAW OR AGREED TO IN WRITING
WILL ANY COPYRIGHT HOLDER, OR ANY OTHER PARTY WHO MAY MODIFY AND/OR
REDISTRIBUTE THE PROGRAM AS PERMITTED ABOVE, BE LIABLE TO YOU FOR
DAMAGES, INCLUDING ANY GENERAL, SPECIAL, INCIDENTAL OR CONSEQUENTIAL
DAMAGES ARISING OUT OF THE USE OR INABILITY TO USE THE PROGRAM (INCLUDING
BUT NOT LIMITED TO LOSS OF DATA OR DATA BEING RENDERED INACCURATE OR LOSSES
SUSTAINED BY YOU OR THIRD PARTIES OR A FAILURE OF THE PROGRAM TO OPERATE
WITH ANY OTHER PROGRAMS), EVEN IF SUCH HOLDER OR OTHER PARTY HAS BEEN
ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
END OF TERMS AND CONDITIONS
Standards Compliance Specifications
Refer to Appendix A, "Specifications," in the Catalyst 6000 Family Installation Guide and the Catalyst
6000 Regulatory Compliance and Safety Information publication for the standards compliance
specifications.

FCC Class B Compliance

This equipment has complies with the limits for a Class B digital device in accordance with the
specifications in part 15 of the FCC rules.
The following information is for FCC compliance of Class B devices: The equipment described in this
manual generates and may radiate radio-frequency energy. If it is not installed in accordance with
Cisco's installation instructions, it may cause interference with radio and television reception. This
equipment has been tested and found to comply with the limits for a Class B digital device in accordance
with the specifications in part 15 of the FCC rules. These specifications are designed to provide
reasonable protection against such interference in a residential installation. There is no guarantee that
interference will not occur in a particular installation.
Modifying the equipment without Cisco's written authorization may result in the equipment no longer
complying with FCC requirements for Class A or Class B digital devices. In that event, your right to use
the equipment may be limited by FCC regulations, and you may be required to correct any interference
to radio or television communications at your own expense.
Note
Refer to the Catalyst 6000 Family Installation Guide and the Catalyst 6000 Regulatory Compliance and
Safety Information publication for additional FCC class compliance information.
Catalyst 6000 Family Network Analysis Module Installation and Configuration Note
72
Modifications to this device not specifically approved by Cisco Systems could void the user's
authority to continue operating the device.
78-10406-05