Cisco Network Analysis Module 6000 Installation And Configuration Manual page 58

Administering the NAM
Command
show interface trunk module slot_number
clock set time date
clock update-calendar
clock read-calendar
Configuration Commands
The following commands are all performed in either global configuration mode or the interface
configuration mode:
•
•
Global Configuration Mode
The following commands are all performed in global configuration mode:
Command
power enable module slot_number
no power enable module slot_number
clock timezone zone offset
clock summer-time zone recurring
clock calendar valid
interface GigabitEthernet slot number/port number
monitor session session {source {interface interface
interface-number | {vlan vlan-id}} [ , | - | rx| tx | both]
monitor session session {destination {interface interface
interface-number} [ , | -] {vlan vlan-id}}
Interface Configuration Mode
The following commands are configuration commands performed in interface configuration mode:
Command
switchport
switchport trunk encapsulation dot1q
switchport trunk native vlan vlan
switchport trunk allowed vlan vlans
switchport mode trunk
switchport capture
switchport access vlan vlan
switchport mode access
Catalyst 6000 Family Network Analysis Module Installation and Configuration Note
58
Global Configuration Mode, page 58
Interface Configuration Mode, page 58
Description
Displays current trunk settings for the interfaces.
Sets the current time and date.
Updates the calendar time to the clock time.
Updates clock time to the calendar time.
Description
Turns the power on for the NAM if it is not already on.
Shuts down the NAM and removes power.
Sets the timezone for the switch or NAM.
Sets the switch to use summertime settings.
Sets the current calendar time as the switch time on startup.
Begins configuration for each NAM port.
Sets the sources for a SPAN session.
Sets the destination for a SPAN session.
Description
Sets interface as a switchport.
Sets dot1q as the encapsulation type.
Sets native VLAN for the trunk port.
Sets allowed VLANs for a trunk.
Sets the interface as a trunk port.
Sets the interface as a capture port.
Sets the access VLAN for the interface.
Sets the interface as an access port.
78-10406-05