Cisco Network Analysis Module 6000 Installation And Configuration Manual page 40

Administering the NAM
New UNIX password:
Retype new UNIX password:
passwd: all authentication tokens updated successfully
If you forget or lose the password, you can enter the clear module password command from the CLI to
restore the password for the root account to "root" and the guest account to "guest."
To restore the NAM password to the factory-set defaults, enter this command in privileged mode:
Router# clear module pc-module mod password
After this command, you must reset the NAM if the software version is 1.2(1).
Note
Resetting the NAM
If you cannot reach the NAM through the CLI or an external Telnet session, enter the hw-mod module
module_number reset command to reset and reboot the NAM. The reset process requires several
minutes.
To reset the NAM from the CLI, perform this task in privileged mode:
Task
Reset the NAM.
This example shows how to reset the NAM, installed in slot 9, from the CLI:
Router#hw-mod mod 9 reset hdd:2
Proceed with reload of module? [confirm] y
% reset issued for module 9
For the boot device, you can specify hdd:1 for the application image or hdd:2 for the maintenance
Note
image.
Router#
00:26:55:%SNMP-5-MODULETRAP:Module 9 [Down] Trap
00:26:55:SP:The PC in slot 8 is shutting down. Please wait ...
To reboot the NAM from the network analysis software, perform this task while you are logged in to the
root account on the NAM:
Task
Reset the NAM.
This example shows how to reboot the NAM:
root@localhost#reboot
Reboot the NAM? [Y/N]:y
System reboot in progress..
Catalyst 6000 Family Network Analysis Module Installation and Configuration Note
40
Command
hw-mod module module_number reset word
The word variable is the string for PC boot device.
Command
reboot
78-10406-05