Fcc Class A Compliance; Related Documentation - Cisco Catalyst 5000 Series Installation And Configuration Note

Step 6

FCC Class A Compliance

This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio-frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference, in which
case users will be required to correct the interference at their own expense.
You can determine whether your equipment is causing interference by turning it off. If the
interference stops, it was probably caused by the Cisco equipment or one of its peripheral devices.
If the equipment causes interference to radio or television reception, try to correct the interference
by using one or more of the following measures:
•
Turn the television or radio antenna until the interference stops.
•
Move the equipment to one side or the other of the television or radio.
•
Move the equipment farther away from the television or radio.
•
Plug the equipment into an outlet that is on a different circuit from the television or radio. (That
is, make certain the equipment and the television or radio are on circuits controlled by different
circuit breakers or fuses.)
Modifications to this product not authorized by Cisco Systems could void the FCC approval and
negate your authority to operate this product.

Related Documentation

For more detailed installation and configuration information, refer to the following publications:
•
Catalyst 5000 Series Installation Guide
•
Catalyst 5000 Series Supervisor Engine Installation Guide
•
Catalyst 5000 Series Module Installation Guide
Catalyst 5500 only—The ATM system processor (ASP), ATM port adapter
Note
carrier, and ATM adapter module LEDs are described in the LightStream 1010 ATM
Switch Hardware Installation Guide. The Catalyst 8510 Campus Switch Router (CSR)
Switch Route Processor (SRP) is described in the Catalyst 8510 Campus Switch Router
documentation. These publications are available on the Cisco Connection Documentation
CD and in print.
If the system does not complete this verification process, refer to Chapter 6,
Note
"Troubleshooting the Installation," in the Catalyst 5000 Series Installation Guide for
troubleshooting procedures.
Your hardware installation is now complete. Refer to the Software Configuration Guide
and Command Reference publication for your switch for complete software configuration
instructions.
Catalyst 5000 Series Supervisor Engine III G Installation and Configuration Note
FCC Class A Compliance
15