Fisher & Paykel RS2484S Installation Manual page 45

Miscellaneous
Attaching the mounting plate
components
Air toe kick seal (1x)
1
Toe kick install kit
Toe kick panel (1x)
Tools
2
Cross-head
screwdriver
M4 hex key (1x)
Attaching the toe kick panel
1
Illustrations may differ from your purchased appliance.
TOE KICK INSTALLATION
toe kick
mounting plate
Re-attach the toe kick mounting plate to the plinth
using same screws that were set aside previously.
air toe kick seal
If toe kick depth is less than 3 5/8" (92mm), attach an
air toe kick seal to the mounting plate.
Peel off the adhesive tape of air toe kick seal and attach
to the middle of the back side of the mounting plate.
Press firmly to ensure the tape adheres to the mounting
plate.
adhesive tape
Peel off the adhesive tape backing of the magnets
attached to the mounting plate.
Ensure the adhesive surface is clean and free of dust
z
or small particles.
Position the toe kick in front of the mounting plate.
The spacers on the toe kick must be aligned with the
z
magnets of the mounting plate.
spacer
Press the toe kick firmly onto the mounting plate to fix
the position.
For custom toe kick, spacers are not needed.
z
For correct dimensions of toe kick, refer to 'Toe kick
z
panel dimensions' for more information.
45