Table of Contents
Advertisement
IMPORTANT!
The door flow divider is pre-assembled to the door of the appliance. It blocks the air flow
from bypassing in front of the bottom grille.
Install the flow divider
Peel the adhesive layer off the flow divider (A).
1
Remove the 8Gx16 countersunk screw from the bottom of the door and
2
re-install the flow divider using the same screw. (Do not tighten fully) (B).
Press the flow divider firmly against the door panel (C). Make sure the
3
adhesive layer contacts the door panel.
Re-tighten the screw fully.
4
C
Attach the flow divider cap to the flow divider (D).
5
Twist to prise open
Note: When fitting the air flow divider to the
door for a toe kick height greater than 4"
(102mm), the divider requires shortening. This
is done by cutting along the cutline on both the
divider and divider cover (E) before installation
to the door. Ensure to file the cut portions of the
divider and cover.
@4
INSTALL FLOW DIVIDER AND DOOR TRIMS
B
D
Expose adhesive
Exploded with machine screw
E
Cut airflow divider for 6" toekick
Required components/tools:
1x Door flow divider
●
●
1x Flow divider cap
●
●
1x 8Gx16 Countersunk screw
●
●
2x Trim caps
●
●
Install the door trims
1
Insert two (2) trim caps (E) into the top door
panel extrusion.
A
Align the notch on the top door panel extrusion
2
(F) with the magnet housing at the top of the
door (G) and clip door top trim assembly into the
magnet housing.
Press the top door panel extrusion down into the
3
top of the door (H) so that the dual lock strips
engage together.
Press the door panel side extrusion (I) into the gap between the door and door panel. Align
4
the top of the door panel side extrusion with the top door panel extrusion. Do on each side.
Top door panel extrusion
●
●
2x Door panel side extrusion
●
●
Saw
●
●
File
●
●
F
G
E
H
H
I
I
I
I
E
39
Advertisement
Table of Contents
