Wall Mounting - Cisco Catalyst Express 500 Getting Started Manual

Chapter 1 Getting Started Guide
Wall-mounting
Step 1
Position the mounting bracket and screw on
the side of the switch, rotated 90-degrees
from the view shown in the rack-mounting
illustration. Tighten the screw with a
screwdriver. Repeat on the opposite side.
Step 2 Mount the switch on the wall with the front panel facing up. For the best support of the switch
and cables, make sure that the switch is attached securely to wall studs or to a firmly attached
plywood mounting backboard. Screws for wall-mounting are not provided.
Step 3
If your switch has a redundant power supply (RPS) connector on the rear panel, make sure
that the cover plate is installed if an RPS is not connected to the switch.
OL-9340-01
Getting Started Guide for the Catalyst Express 500 Switches
Install the Switch
1-11