Table of Contents
Advertisement
PROBLEM
Linting.
Fabric damage.
TROUBLESHOOTING
POSSIBLE CAUSES
Lint filter not cleaned or
replaced.
Dryer is overloaded.
Loads not sorted correctly.
Clothes over dried.
New items have been dried
in the dryer recently.
Delicate items not dried on
an appropriate cycle.
Metal parts on the items or
in the load.
Items not separated or dried
on an appropriate cycle for
the fabric type.
Items fell off the rack when
using 'Rack Dry'.
'Dry Temp' or 'Dryness
Level' selected not
appropriate for the fabric
type.
Used a 'Time Dry' cycle and
did not monitor the dryness
of clothes during the cycle.
Instructions on care label
not followed.
WHAT TO DO
Ensure the lint filter is cleaned after
every cycle and replaced correctly.
Refer to page 22.
Remove some items from the dryer.
Dry lint givers separately from lint
receivers. Refer to page 17. Also,
dry similar colours together eg light
coloured items with light coloured
items, dark items with dark items.
Refer to page 17.
Over drying clothes in the dryer can
cause them to attract lint. Use an
auto sensing cycle or ensure you
check your load if using the time
dry cycles to avoid over drying.
Refer page 18.
New towels or flannelette sheets
can leave lint in the dryer, which
may be picked up by subsequent
loads.
Dry delicate items on 'Delicate' or
'Rack Dry' cycles. Refer pages 15
and 18.
Fasten zips and other clasps before
placing items in the dryer.
Dry similar items together. Ensure
an appropriate cycle is selected.
Refer to pages 15 and 18.
Ensure the rack is installed correctly
(refer to page 17) and only one or
two garments are placed on the
rack at a time.
Ensure the 'Dry Temp' and 'Dryness
Level' selected is appropriate for the
fabric type. Refer to the items care
label. Refer to page 19.
Ensure that clothes are checked for
dryness during the cycle when using
the timed programmes to avoid
over drying. Refer to page 18.
Follow the instructions on the care
label of the items.
31
Advertisement
Table of Contents
