Table of Contents
Advertisement
LE3200P
HTW250/240P
Starting and stopping (Fig. 1)
Starting
NOTE: Do not squeeze the throttle lever (2) before starting.
1. Press the On/Off switch (1) on the handle to the On (I) position.
2. Press the primer bulb (17) 6 times.
3. Push the choke lever (18) up to the start position
NOTE: Pressing the primer bulb (17) and setting the choke lever (18) to the start
position is unnecessary if the engine is warm or you work with the machine in warm
conditions.
4. Pull the recoil starter (13), till the engine starts.
5. Once the engine has started, allow it to warm up for 2 minutes. Once warm, move
the choke lever (18) to
6. Tilt the machine backwards at the upper handle (3), so that the cutting blade (8) is
clear of the ground.
7. Squeeze the throttle lever (2) to move the cutting blade (8).
Stopping
1. Release the throttle lever (2) so that the engine is idling and the cutting blade (8)
stops spinning.
2. Press the On/Off switch (1) on the handle to the Off (0) position.
Edging (Fig. 1)
m WARNING! Before edging, check that the area is clear of any obstacles and
objects that could be thrown.
NOTE: If the cutting depth needs adjusting, this should be done progressively until
the desired depth is reached. Do not overload, keep initial cutting depth at minimum.
If the edger slows, pull back slightly and wait until the cutting blade (8) returns to
normal speed.
1. While the engine is idling, line up the lawn edger cutting blade (8) with the edge to
be cut. Use the arrow label on the blade guard (9) to assist in guiding you where
the cutting blade will cut.
2. Before beginning to edge, tilt the upper handle (3) down so the cutting blade (8) is
above ground level. This assists in the prevention of kickback.
3. When starting to edge, pull the throttle lever (2). Run the engine at full throttle and
lower the cutting blade (8) gently into the ground. Be careful not to hit concrete
AFTER SALES SUPPORT
AFTER SALES SUPPORT
1300 855 831
00800 4003 4003
position.
MODEL: HTW250/240P PRODUCT CODE: 64055 xx/2017
MODEL: LE3200P PRODUCT CODE: 61520 08/2018
.
aldi.service.uk@scheppach.com
support@scheppach.com.au
AUS
Introduction
Operation
19
9
Advertisement
Table of Contents
