Prior To Installation - Fisher & Paykel DW60U6I Installation Manual

2
PARTS SUPPLIED
Drain hose
Inlet hose (1) support (1)
Moisture protection Hex key (1)
tape (1) (to prevent
moisture damage to
cabinetry)
Unpacking and handling
Check packaging and dishwasher for signs of transport damage. If the dishwasher is in any way damaged, do not install it. Contact the dealer the dishwasher was purchased from.
Disposal of packaging: some of the packaging is recyclable. Check the symbols and labels and recycle if possible.
Always be careful with the hoses and power cord at the back of the dishwasher. Careful handling will prevent damage and malfunction from squashing, kinking or cuts.
While installing the dishwasher, check the drain hose is not restricted or kinked.
Connections and services
Check that the power cord is long enough to reach the outlet. If it isn't, it must be replaced by a Fisher & Paykel authorised technician. Extension cords or multi-outlet power boards should not
be used to connect the dishwasher to the power supply.
Check that the hoses are long enough to reach the services. If a hose needs extending, ensure that the extension hose is new and of equal quality and diameter to the one already fitted. Note:
the drain hose should not be longer than 4 m, as a longer drain hose will cause reduced performance.
The dishwasher should not be connected to a water system where the temperature exceeds 60
suitable tempering valve.
The dishwasher must not be connected to an undersink high-pressure "push-through" type hot water system, as damage to the system will result.
Plastic slider (1) Installation guide
and template and
user instructions
Ø3.9 x 38mm
screws (4)
Brackets for Ø3.5 x 12mm
toekick (2) screws (4)
4

PRIOR TO INSTALLATION

Technical data
Check the electrical data on the rating label (located on the left-hand side of the
dishwasher's stainless steel inner door). Should the data on the rating label be different
to those specified below, consider those on the rating label as correct.
Capacity
Plastic Mains water
spacers (2)
pressure
Power voltage
Maximum current
intensity
Total absorbed
Ø3.9 x 13mm
power
screws (4)
Anti-flood protection
Ø4 x 25mm
screws (4)
This dishwasher has anti-flood protection, which will stop the water flowing in the event
of a leak within the machine.
o C, or where there is no temperature control, e.g. wetback system, unless the system is fitted with a
3
TECHNICAL DATA
DW60U2I1 models DW60U6I1 models
15 place settings 15 place settings
0.03-1 MPa 0.03-1 MPa
(= 0.3-10 bar) (= 0.3-10 bar)
220-240 V (50 Hz) 220-240 V (50Hz)
10 A 10 A
1720-2050 W 1720-2050 W
1