Installation Of Second Unit - Hoshizaki KM-1601SRH Instruction Manual

(g) Remove the  screws from the lower part of the thermostat bracket (plastic) and
use them to attach the thermostat extension bracket (stainless) to the thermostat
bracket (plastic).
Thermostat Extension
Bracket (stainless)
Thermostat Bulb
Attachment (plastic)
6) Level the icemaker/storage bin in both the left-to-right and front-to-rear directions.
Adjust the storage bin legs to make the icemaker level.
7) Replace the panels and baffle in their correct positions (unless you are installing a
second unit).
Note: The bin control thermostat must be checked for proper operation at startup.
E. Installation of Second Unit
See Fig. 6
1) See "II.D. Setup" for the lower unit installation.
) Remove the top panel and the top
insulation of the lower unit. These pieces
must be removed when installing a second
icemaker.
3) Unpack the second icemaker (upper unit),
and remove the shipping carton, tape, and
packing material.
4) Remove the panels of the second
icemaker.
5) Stack the upper unit on top of the lower unit.
6) Secure the upper unit to the lower unit by using the  mounting brackets and the bolts
provided.
7) Remove the tie securing the upper unit's bin control thermostat assembly.
8) Remove the bin control thermostat assembly from the shipping hook by lifting it up and
shifting it to the right.
Fig. 5
Mounting
Brackets
Bolts
Fig. 6
13
Thermostat Bracket
(plastic)
Icemaker
(Upper Unit)
Icemaker
(Lower Unit)
Bin