Installation Of The Second Unit - Hoshizaki KM-1600SRH Instruction Manual

5. INSTALLATION OF THE SECOND UNIT - See Fig. 4, 5 5. INSTALLATION OF THE SECOND UNIT - See Fig. 4, 5 5. INSTALLATION OF THE SECOND UNIT - See Fig. 4, 5
5. INSTALLATION OF THE SECOND UNIT - See Fig. 4, 5 5. INSTALLATION OF THE SECOND UNIT - See Fig. 4, 5
1) See "4. SET UP" for the lower unit installation.
2) Remove the Top Panel and the Top Insulation of the
lower unit. The Top Panel and the Top Insulation of
the lower unit are not required when installing the
second icemaker.
3) Unpack the second icemaker (upper unit), and
remove all shipping cartons, tape(s) and packing.
4) Remove the panels of the second icemaker.
5) Stack the upper unit on top of the lower unit.
6) Secure the upper unit to the lower unit by using the
two Universal Braces and the four bolts provided.
7) Remove the Thermostat Bulb Attachment of the upper unit from the Thermostat
Bracket.
8) Route the Bin Control Thermostat Capillary Tubing of the upper unit through the bottom
hole of the upper unit and the Thermostat Bracket of the lower unit.
Secure the Thermostat Bulb of the upper unit to the Thermostat Bulb Attachment of the
lower unit with the Thermostat Bulb Attachment and the screws of the upper unit.
9) Insert the plug of the upper unit into the receptacle of the upper unit on the Bracket until
it locks in place.
10) Place the panels in position.
Fig. 5 Fig. 5
Fig. 5 Fig. 5 Fig. 5
14
Fig. 4 Fig. 4
Fig. 4 Fig. 4 Fig. 4