Installation And Operating Instructions; Checks Before Installation; How To Remove Panels - Hoshizaki KM-1601SRH Instruction Manual

II. Installation and Operating Instructions
A. Checks Before Installation
1. Install in accordance with all applicable national, state, and local regulations.
. Remove the shipping carton, tape, and packing material. If any are left in the
icemaker, it will not work properly.
3. Ensure all components, fasteners, and thumbscrews are securely in place
after installation.
1) Remove the panels to prevent damage when installing the icemaker. See "II.B. How to
Remove Panels."
) Remove the package containing the accessories from the compressor compartment.
3) Remove the protective plastic film from the panels. If the icemaker is exposed to the
sun or to heat, remove the film after the icemaker cools.
4) Check that the refrigerant lines do not rub or touch lines or other surfaces.
5) Check that the compressor is snug on all mounting pads.
6) See the nameplate on the rear panel, and check that your voltage supplied
corresponds with the voltage specified on the nameplate.
7) This icemaker needs a storage bin. The recommended storage bin is HOSHIZAKI ICE
STORAGE BIN, Model B-800 series or larger.
8) On remote air-cooled models, a remote condenser unit is needed. The recommended
remote condenser unit is HOSHIZAKI REMOTE CONDENSER UNIT, Model URC-1F.
B. How to Remove Panels
See Fig. 1
• Front Panel: Remove the  screws. Lift up and pull
towards you.
• Top Panel: Remove the  screws, and then lift off.
• Side Panel (R): Remove the screw. Pull slightly
towards you, and take off.
• Insulation Panel: Remove the thumbscrew. Lift up
slightly, and pull towards you.
IMPORTANT
Insulation
Panel
Front
Panel
10
Top Panel
Side
Panel (R)
Fig. 1