Kenwood CS-2110 Instruction Manual page 9

P O W E R S U P P L Y / C R T D I S P L A Y C O N T R O L S
® A I N T E N S I T Y , B I N T E N S I T Y Controls
A l l o w s adjustment of intensity for the A s w e e p and B
s w e e p respectively.
A I N T E N S I T Y ;
Adjusts the trace intensity for the A s w e e p and
the display intensity for X - Y operation.
B I N T E N S I T Y ;
Adjusts the intensity of the B sweep.
® P O W E R , S C A L E I L L U M Controls
Fully counterclockwise rotation (off position) turns off
oscilloscope. Clockwise rotation turns on oscillos-
cope. Further c l o c k w i s e rotation of the control i n -
creases the illumination level of scale.
(§) L E D Pilot Lamp
Indicates that the power supply has been turned on.
@ A S T I G Control
Astigmatism adjustment
roundness when used in conjunction with
control regardless intensity control.
C O N T R O L S A N D I N D I C A T O R S
Fig. 2
provides optimum spot
F O C U S
© F O C U S Control
Used to adjust the trace for optimum focus.
Auto-focus circuit keeps waveform
changes in intensity.
<§> T R A C E R O T A T I O N Control
Electrically rotates trace to horizontal
Strong magnetic fields may cause the trace to be tilt-
ed. T h e degree of tilt may vary a s the scope is moved
from one location to another.
this control.
C A L , 1 V p - p , « 1 kHz Terminal
#
Provides 1 kHz, 1 Volt peak-to-peak square w a v e s i g -
nal. T h i s is useful for probe compensation
ment.
® Jm G N D Terminal/Binding post.
Ground terminal - use it to connect the instrument to
the earth ground.
in f o c u s w i t h
position.
In these cases, adjust
adjust-
9