Changing The Saw Blade - Mafell MKS185Ec Operating/Safety Instructions Manual

4.5 Changing the saw blade

Use the following procedure to change the saw
blade:
1. Pull out the power plug of the machine.
2. Put down the cable where you can see it.
3. Put the disconnected machine on a flat
surface.
4. Press and hold the locking pin (10).
The mechanism that locks the saw shaft
➢
is activated.
5. Using the Allen key (B), turn the flange screw
(12) counterclockwise to loosen it.
You can now release the locking pin.
➢
6. Remove the flange screw (12) and the front
clamping flange (13).
16
Caution
Risk of injury from the sharp saw blade
The saw blade is sharp. You can hurt yourself when you change the saw blade.
Wear protective gloves when you change the saw blade.
➢
➢ Be careful when you change the saw blade.
Fig. 7: Locking the saw blade
Fig. 8: Removing flange screw and clamping flange
MKS185Ec
01/2022