Other Management Options; In Case Of Difficulty - Cisco Catalyst 3020 Getting Started Manual

Cisco catalyst blade switch 3020 for hp

Hide thumbs Also See for Catalyst 3020:

Table of Contents

No parity

–

1 stop bit

–

No flow control

–

4. Use the CLI to enter commands to configure the switch module. See the software configuration

guide and the command reference for more information.

Other Management Options

You can use SNMP management applications such as CiscoWorks Small Network Management

Solution (SNMS) to configure and manage the switch module. You also can manage it from an

SNMP-compatible workstation that is running platforms such as HP OpenView or SunNet Manager.

The Cisco IE2100 Series Configuration Registrar is a network management device that works with

embedded Cisco Networking Services (CNS) agents in the switch module software. You can use

IE2100 to automate initial configurations and configuration updates on the switch module.

See the "Accessing Help Online" section on page 23 for a list of supporting documentation.

Onboard Administrator Command-Line Interface

See the HP BladeSystem enclosure setup and installation guide at

http://www.hp.com/go/bladesystem/documentation

Administration CLI.

If you experience difficulty, help is available in this section and also on Cisco.com. This section

includes Express Setup troubleshooting, how to reset the switch module, how to access online help,

and where to find more information.

for information on how to use the Onboard

Table of Contents