Cisco Catalyst 3020 Getting Started Manual page 3

If the switch modules are ordered with the blade server, the switch modules are already installed.
The unpacking procedure for the switch module applies only if one is ordered separately. See the blade
server documentation for the unpacking procedure for the HP equipment.
Cisco Gigabit Ethernet Switch Module Description
The Cisco Catalyst Blade Switch 3020 for HP is a 24 Gigabit Ethernet port, Layer 2+ switch module.
Sixteen of the Gigabit Ethernet ports are internal 1000BASE-X downlink ports that connect to the
blade server. The other eight Gigabit Ethernet ports are external uplink ports that provide connections
to other switches or routers. Uplink ports operate at 10/100/1000 Mbps if used as RJ-45 ports and
operate at 1000 Mbps if
Table 1 for more detailed descriptions of the switch module ports.
Figure 1 shows the switch module.
Figure 1 The Catalyst Blade Switch 3020 for HP
2
6
1
S Y S T
S T A T
1 7
D L X
U ID
S P D
M O D E
C O N S
W S -C B
O L E
S -3 0 2 0
2 0
-H P Q
1 7
4
5
7
8
3
Switch module
1
Release latch
2
3 System status LEDs
Mode button
4
5 Console port
1
UID LED
6
1. UID: unit identifier
The switch module is managed through the RS-232 console port that uses an RJ-45 connector in the
switch module front-panel.
small form-factor pluggable (SFP) fiber-optic modules are installed. See
9
10
1 7 x
1 7 x
2 1 x
1 8
1 9
2 0 x
2 0 2 4 x
1 8 x
Health LED
7
SFP module port LEDs for ports 17 to 20
8
9 SFP module ports 17 to 20
10 Gigabit Ethernet ports LEDs for ports 17x to 24x
11 Gigabit Ethernet ports 17x to 24x
11
2 3 x
2 4 x
3