Completing The Express Setup Fields - Cisco Catalyst 3020 Getting Started Manual

Cisco catalyst blade switch 3020 for hp

Hide thumbs Also See for Catalyst 3020:

Table of Contents

The Express Setup page appears.

Go to "Completing the Express Setup Fields" section on page 17 to finish setting up the switch

Step 8

module using the Express Setup screen of the Device Manager.

Completing the Express Setup Fields

Follow these steps to finish setting up the switch module:

Enter this information in the Network Settings fields:

Step 1

In the Management Interface (VLAN ID) field, the default is 1. Enter a new VLAN ID only if

–

you want to change the management interface through which you manage the switch module

and to which you assign IP information. The VLAN ID range is 1 to 1001.

In the IP Address field, enter the IP address of the switch module. In the IP Subnet Mask field,

–

click the drop-down arrow, and select an IP Subnet Mask.

In the Default Gateway field, enter the IP address for the default gateway (router).

–

Enter your password in the Switch Password field. The password can be from 1 to 25

–

alphanumeric characters, can start with a number, is case sensitive, allows embedded spaces,

but does not allow spaces at the beginning or end. In the Confirm Switch Password field, enter

your password again.

Table of Contents