Troubleshooting Express Setup - Cisco Catalyst 3020 Getting Started Manual

Troubleshooting Express Setup

If Express Setup does not run, or if the Express Setup page does not appear in your browser:
• Did you verify that POST successfully ran
before starting Express Setup?
• Did you press the Mode button while the
switch module was still running POST?
• Did the switch module not power up?
• Did you try to continue without confirming
that the switch module was in Express Setup
mode?
• Does your PC have a static IP address?
• Did you connect a crossover cable instead of
a straight-through Ethernet cable between a
switch module port and the Ethernet port of
the PC?
• Did you connect the Ethernet cable to the
console port instead of to an Ethernet port
on the switch module?
22
If not, make sure that only the SYST and STAT
LEDs are green before pressing the Mode button
to enter the Express Setup mode.
If yes, wait until POST completes. Power cycle the
switch module. Wait until POST completes.
Confirm that the SYST and STAT LEDs are green.
Press the Mode button to enter Express Setup
mode.
The switch module is controlled by the Onboard
Administrator. If the switch module does not
power up, see the blade server documentation for
more information.
Verify that all LEDs next to the Mode button are
green. If necessary, press the Mode button to
enter Express Setup mode.
If yes, before connecting to the switch module,
change your PC settings to temporarily use
DHCP.
If yes, connect a straight-through cable to an
Ethernet port on the switch module and the PC.
Wait 30 seconds before you enter 10.0.0.1 in the
browser.
If yes, disconnect the cable from the console port.
Then connect the cable to an Ethernet port on the
switch module and the PC. Wait 30 seconds
before you enter 10.0.0.1 in the browser.