Download Print this page

Using The Onboard Administrator To Assign An Ip Address To The Switch Module Fa0 Interface - Cisco Catalyst 3020 Getting Started Manual

Cisco catalyst blade switch 3020 for hp

Hide thumbs Also See for Catalyst 3020:

Table of Contents

Enter the IP address 10.0.0.1 and press Enter.

Step 9

The Express Setup home page appears.

Step 10 Go to "Completing the Express Setup Fields" section on page 17 to finish setting up the switch

module using the Express Setup screen of the Device Manager.

Using the Onboard Administrator to Assign an IP Address to the

Switch Module fa0 Interface

For the switch module to obtain an IP address for the fa0 interface through the Onboard

Administrator, these conditions must be met:

• The blade server is powered on and connected to the network.

• Basic configuration of the Onboard Administrator is completed, and you have the username and

password for the Onboard Administrator.

• A DHCP server is configured on the network segment to which the blade server is connected,

or the Onboard Administrator is configured to run as a DHCP server.

See the Onboard Administrator user guide at

Note

http://www.hp.com/go/bladesystem/documentation

and using the Onboard Administrator.

for more information about configuring

Table of Contents