Command Line Interface - Cisco Catalyst 3020 Getting Started Manual

Cisco catalyst blade switch 3020 for hp

Hide thumbs Also See for Catalyst 3020:

Table of Contents

3. Use the device manager to perform basic switch module configuration and monitoring. Refer to

the device manager online help for more information.

4. For more advanced configuration, download and run the Cisco Network Assistant, which is

described in the next section.

Command-Line Interface

You can enter Cisco IOS commands and parameters through the CLI. Access the CLI either by

connecting your PC directly to the switch module console port or through a Telnet session from a

remote PC or workstation.

Follow these steps:

1. Connect the supplied RJ-45-to DB-9 adapter cable to the standard 9-pin serial port on the PC.

Connect the other end of the cable to the console port on the switch module.

2. Start a terminal-emulation program on the PC.

3. Configure the PC terminal emulation software for:

9600 baud

–

8 data bits

–

Table of Contents