Related Manuals for Hoover savvy
Summary of Contents for Hoover savvy
- Page 1 Upright Vacuum Cleaner by HOOVER Owner's Manual ENGLISH -I, pp. 1-11 ESPANOL -I, pag. 13-19 FRANGAIS -i, p. 21-31 Congratulations on your purchase! This product was designed www.hoover.com easy assembly (see page 3)
- Page 2 If appliance is not working as it should, been dropped, damaged, left outdoors, or dropped into water, take it to a Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot). © 2004 The Hoover Company •...
- Page 3 If you need any assistance: Visit our website at www.hoover.com. Click on the "Service" button to find the service outlet nearest you Call 1-800-944-9200 for an automated referral of service outlet locations (U.S. only) Call 1-330-499-9499 to speak with a representative...
-
Page 4: Custom Control Switch
Push screws into holes on back of Place hose on holder. Remove label (C) from Custom Control switch. handle (Fig. 1-6) and hose holder (Fig. 1-7). If label has come off during assembly, make sure switch is in Tighten screws securely with a OFF (down) position before plug- Phillips screwdriver. -
Page 5: Handle Positions
p_,€] Handle positions Transporting cleaner Carrying cleaner Put handle in upright position. Tilt clean- The handle of your cleaner has three Use the carrying handle to lift the er back on rear wheels. Push forward. cleaner. positions; upright for storage and when using cleaning tools;... -
Page 6: Cleaning Tools
Cleaning tools When using cleaning tools, cleaner han- dle should be in the upright position to activate the automatic "brush roll OFF" and for convenience in moving the cleaner from one area to another. Attach wand tools Select proper tool F. -
Page 7: Filter Bag
HOOVER filter bags distributed tively. by The Hoover Company to assure that NOTE: All new carpet has loose fibers your cleaner operates at peak perfor- which can fill the bag quickly while mance. - Page 8 Headlight replacement What to buy This cleaner uses a 12 volt, wedge base type 912 bulb, HOOVER part No. 27313107. Install bulb - Pull old bulb straight Replace lens - Place one tab (!:) on lens into slot. Press on lens and secure out of socket.
- Page 9 When agitator brush roll brushes are worn, the brush roll should be replaced. Ask for HOOVER part No. 48414088. 2. Unscrew the two Phillips screws and 3. Remove agitator including end plates (C) and discard. remove belt guard (B).
- Page 10 • Allow cleaner to cool (this will reset the thermal protector) (see pg. 10). Heever Cleaning • Filter bag full • Change filter bag. This Hoover Cleaning Performance Sys- • Incorrect carpet height setting tem is for comparing the relative pro- • Move nozzle control knob to lower...
- Page 11 Hoover Company on=line at rights which vary from state to state www, hoover, com (or province). Do not send your cleaner to The Hoover If further assistance is needed, or if Company in North Canton for service, there are questions concerning...