General Safety Information - SEBSON HD GS412 Manual

support@sebson.de
UST-IDNr.: DE246981805
WEEE-Reg.-Nr.: DE 78960174
Manual
Thank you for choosing a product of SEBSON. Read the instructions carefully and keep them for looking up before
start-up this product. A long and failure-free operation can only be guaranteed if the installation and start-up is done
properly. Before starting up this product, please check for external damage. In case of visible external damage we
immediately dis-advise the start-up of this product! Please remove all packaging material of this product before the
first start-up an and check the content for completeness!
Intended use:
This heat detector is used for early warning of dangerous heat development. As soon as an ambient temperature of
more than 54°C is reached, a loud alarm will sound and the LED will flash. This is a radio alarm that can be networked
with up to 15 other radio alarms (e.g. carbon monoxide alarms or water alarms) of the same manufacturer and the
same product series via radio. As soon as this heat alarm detects a temperature above 54°C, it sends a signal to all
devices that are connected to this device via radio. All networked devices then switch to alarm mode.
Scope of delivery:
 1 Heat detector
 2 x 1,5V DC type: AA batteries
 Screws for fixing (2 pieces)
 Dowels Ø 6mm (2 pieces)
General information about the product:
Note:
Consult a specialist with regard to the installation and in particular the positioning of the device in the
intended rooms in order to ensure that the proper functioning of the heat detector is guaranteed!
 1: TEST-button; 2: LED; 3: Speaker (see Fig. 2)
 This heat detector may only be used in private rooms!
 Activate the heat alarm before installation and check the unit for proper functioning on a weekly basis (see
chapter: "Start-up")!
 The unit must be replaced after 10 years at the latest!
 This heat detector can detect excessive heat development at an early stage. This device cannot prevent a
fire or excessive heat development!
 This detector does not react to smoke, flames or gas!
 This device can monitor a range of 20 to 40m².

General safety information:

Danger:
Never paint or use other solvents on the housing! Never hang any decorative items on the housing and
never cover it! This means that the proper functioning of the device is no longer guaranteed!
Danger of suffocation:
that can be swallowed!
Attention:
Never test the heat detector with an open flame, e.g. a candle or the flame of a lighter! You will damage
the built-in sensor!
Keep this product away from children and animals! The packaging contains small parts
11