Entering Roman Character-Converted Kana - Epson S5U1C88348T Manual

Cmos 8-bit single chip microcomputer

Table of Contents

7 KEY INPUT

7.3 Entering Roman Character-Converted Kana

The S5U1C88348T demonstration program provides a function for converting Roman characters into the

Japanese syllabary, hiragana or katakana.

Setting Roman character-converted kana input mode

Press the [Char] key to display "CTRL" on the left side of the LCD panel. The Roman characters

entered in this mode are converted into kana. To enter Roman characters, refer to the Roman to Kana

Conversion Table.

Press the [Char] key when "CTRL" appears on the LCD panel to enter ordinary English input mode.

Numbers and symbols can be entered as described earlier, whether or not "CTRL" is displayed.

Switching between hiragana and katakana

Roman characters are converted into katakana when "CAP" appears on the LCD panel, or into

hiragana when "CAP" does not appear. Toggle between the two modes by pressing the [Caps] key.

Roman to kana conversion table

I-16

Table 7.3.1 Roman to Kana Conversion Table

EPSON

S5U1C88348T OPERATION MANUAL

Table of Contents

Table of Contents