Hardware Of The Cc-Link Interface Card; Card Overview; Dip Switch - Mitsubishi Electric MELFA CR800-D Series Instruction Manual

3.3. Hardware of the CC-Link Interface Card

This section describes the settings that are performed by using the rotary switches and DIP switches on the
CC-Link interface card.

3.3.1. Card overview

(1) General Layout of the Card
ＬＥＤ
CC-Link cable
connection connector

3.3.2. DIP switch

There are the three DIP switches (SW1 / SW2 / SW3) on the CC-Link interface card (TZ576).
The item which can be set up with each DIP switch is shown in the following.
Table 3.3-1 Function of DIP switch (SW1)
Switch
1
Ver.1 mode
2
SW1
3
4
Figure 3.3-1 General Layout of the Card
OFF ON
ON (fixation)
Ver.2 mode
OFF (fixation)
OFF (fixation)
DIP switch（SW1/SW2/SW3）
Factory
setting
ON
ON
OFF
OFF
10
Description
Specify the version of CC-Link.
In case of the Ver.2 mode, the
extended cyclic setup is possible.