USING THE STAND MIXER
ATTACHING/REMOVING THE FLAT BEATER, FLEX EDGE BEATER*,
WIRE WHIP, OR DOUGH HOOK
Hold the locking lever in the UNLOCK
2
position and tilt motor head back�
To remove accessory: Repeat steps
1 and 2� Press accessory upward
4
as far as possible and turn to the
left� Then pull accessory from the
beater shaft�
*Included with select models only� Also available as optional accessory�
10 | USING THE STAND MIXER
Book.indb 10
To attach accessory: Turn speed
1
control to "0"� Unplug Stand Mixer�
Slip accessory onto beater shaft and
press upward as far as possible� Then,
3
turn accessory to the right, hooking
accessory over the pin on the shaft�
5/4/2018 7:24:26 PM