KitchenAid 5K45 Manual page 14

USING THE STAND MIXER
Insert attachment shaft housing into
attachment hub, making certain that
attachment power shaft fits into
square attachment hub socket� It may
3
be necessary to rotate attachment
back and forth� When attachment
is in proper position, the pin on the
attachment will fit into the notch
on the hub rim�
To remove: Turn speed control
5
to "0"� Unplug Stand Mixer�
Replace attachment hub cover�
7
Tighten attachment knob by turning
it clockwise�
NOTE: See the Use and Care Guide of each specific attachment for recommended
speed settings and operating times�
14 | USING THE STAND MIXER
Book.indb 14
Tighten attachment knob by turning
clockwise until attachment is
4
completely secured to Stand Mixer�
Plug into proper electrical outlet�
Loosen attachment knob by
turning it counterclockwise� Rotate
6
attachment slightly back and forth
while pulling out�
5/4/2018 7:24:27 PM