Counter Memory; To Exit The Counter Memory - Hitachi VT-MX4510A Owner's Manual

COUNTER MEMORY

• Use the remote control for the following procedure.
• Be sure to check that the "PWR." and the "VCR" indicators are both on.
• Turn on the TV and set the TV to channel 3 or 4. Now set the CH3/CH4 switch on the back of the VCR
to match the channel selected on the TV.
.
1 Stop tape at your desired point
Rewind or fast forward the tape to the beginning point at which you want to review.
2 Reset the counter to 0:00:00
Press the COUNTER RESET button on the remote. If necessary press the COUNTER RESET button
again to reset the counter to 0:00:00.
3 Select the Counter Memory mode
Press the COUNTER MEMORY button on the remote control until "M" appears on the TV screen.
• The COUNTER MEMORY button does not function if the Auto Repeat mod is set ot [ON]. In this case,
set the Auto repeat mode to [OFF].
M 0:00:00
4 Begin recording or playback
Press REC or PLAY button.
Press the STOP button when recording or playback is completed.
5 To activate the Counter Memory
Press the REW (or F.FWD) button, the VCR will stop automatically when the counter has returned to
approximately 0:00:00.
NOTE: The displayed time will not change during blank portions on the tape.

TO EXIT THE COUNTER MEMORY

Press COUNTER MEMORY button on the remote control so that "M" disappears from the TV screen.
On more information concerning the on screen display, please refer to page 32.
25