Controlling The Tv; Troubleshooting Guide - Hitachi VT-MX4510A Owner's Manual

CONTROLLING THE TV

Once programmed, the VCR's remote control is ready to control the TV.
NOTE:
Be aware that not all of your TV's functions may work even though the remote control is correctly
programmed.
1. Select the TV function mode
First press the TV button to change to the TV function mode, then press the button of the TV function that
you want.
For example;
Press the TV button and the CH (
NOTE:
Also, you may change the channels at the TV by using the number buttons. If you can not change the
channels at the TV by using the number buttons, press the ENTER button after you press the number
buttons. It may change channels at the TV.
2 Return to the VCR function mode
Press the VCR button to operate your VCR with the remote again.

TROUBLESHOOTING GUIDE

If you have followed the instructions contained in this manual and have difficulty in operating your VCR,
locate the PROBLEM in the left column below. Check the corresponding CORRECTIVE ACTION
columns to remedy the problem.
PROBLEM
No power.
Timer recording is not possible.
Cannot go into Record mode.
Playback picture is partially noisy
No picture but the audio is OK in playback. • Head cleaning may be necessary. Refer to "HEAD CLEANING" on
No picture or poor picture on playback.
On-the-air TV programs cannot be seen.
No operation from the infrared
Remote Control
Video or color fades in and out when
making a copy of a video tape
), and the TV station will change to the next higher station.
• Make sure the AC cord is connected to an AC outlet.
• Make sure the power is turned on.
• Make sure the timer recording is set correctly.
• Make sure the VCR clock is set correctly.
• Make sure the tape has an erase-prevention tab. If needed, cover
• Adjust tracking control for a better picture by using the CHANNEL
• Set your TV to the VCR mode and/or press the VCR/TV button on
the remote control so that the "VCR" indicator on the display comes
• Re-check the ANT. IN and ANT.OUT connections. See page 10.
• Set your TV to the TV mode and/or press the VCR/TV button on the
remote control so that the "VCR" indicator on the display disappears..
• Make sure the AC cord is connected to an AC outlet.
• If the TV or CATV button is selected, press the VCR button on the
• You cannot copy a copyrighted video tape. You are experiencing
41
CORRECTIVE ACTION
• Make sure the power is off.
the hole with plastic tape.
or button on the VCR.
page 32.
on.
• Fine tune your TV.
• Check batteries in remote control
remote control
copy guard protection.