Connecting An Adsl Line-Adsloisdn Port - Cisco 520 Hardware Installation Manual

Connecting an ADSL Line—ADSLoISDN Port
You can connect the ADSL cable directly to a cable wall jack or you can connect it to the wall jack using
a splitter.
To connect the ADSL cable, perform one of the following, as appropriate:
•
•
Connecting an ADSL Line—ADSLoISDN Port
This section applies only to the Cisco Secure Router 520 ADSL-over-ISDN router. The procedure for
connecting an asymmetric digital subscriber line (ADSL) depends on the router and, in some cases, on
the location.
Note The DSL line must have been provisioned by your service provider and correctly configured so that the
ADSL CD LED shows the status. If the ADSL CD LED is not on, contact the DSL service provider.
You must provide the unshielded Category 5 cable for connecting to the ADSL ISDN splitter. The ADSL
Note
ISDN splitter is provided by the DSL service provider.
Cisco Secure Router 520 Series Hardware Installation Guide
4-10
To connect the ADSL cable directly to a cable wall jack see
these steps:
Connect one end of the ADSL cable to the ADSLoPOTS port on the router.
–
Connect the other end of the cable to the wall jack.
–
To connect the ADSL cable to a cable wall jack using a splitter, see
follow these steps:
Although Figure 4-8
Note
splitter is the same for both ADSLoPOTS and ADSLoISDN ports.
Connect the RJ-11 end of the ADSL cable to the ADSLoPOTS port on the router.
–
Connect the other RJ-11 end of the ADSL cable to the local ADSL connector port on the ADSL
–
splitter. The ADSL splitter is provided by the DSL service provider.
Connect the unshielded Category 5 cable from the outside ADSL port on the splitter to a wall
–
jack.
You must provide the unshielded Category 5 cable for connecting to the splitter. The splitter
Note
is provided by the DSL service provider.
shows an ADSL-over-ISDN (ADSLoISDN) port, the connection to the
Chapter 4 Router Installation
Figure 4-7 on page 4-9. Then follow
Figure 4-8 on page 4-11. Then
OL-12892-01