Cisco 520 Hardware Installation Manual page 32

Mounting the Router on a Wall
To install the router on a desktop, table, or other flat surface, follow these steps:
Place the unit upside-down on the flat surface.
Step 1
Attach the four rubber pads to the recessed areas on the bottom of the unit.
Step 2
Place the unit right-side-up on the flat surface.
Step 3
Step 4 If you have a wireless router, connect the radio antenna to the router (see the
Antenna to a Wireless Router" section on page
Place the power supply unit on a desktop near an AC power source. Do not stack the power supply on
Step 5
the router.
Mounting the Router on a Wall
You can mount the Cisco Secure Router 520 Series router on a wall or other vertical surface. There are
two mounting-screw holes on the bottom of the router for mounting the unit.
mounting-screw holes.
Figure 3-1
2
1
Cisco Secure Router 520 Series Hardware Installation Guide
3-2
Mounting-Screw Holes on the Bottom of the Cisco Secure Router 520 Series Router
1
Front panel facing upward
3-1).
8.25 in. (20.9555 cm)
2
Mounting-screw holes
Chapter 3 Router Mounting Procedures
"Connecting a Radio
Figure 3-1 shows the
OL-12892-01
2