Installing The Cisco Secure Router 520 Ethernet-To-Ethernet Router - Cisco 520 Hardware Installation Manual

Typical Installation

Installing the Cisco Secure Router 520 Ethernet-to-Ethernet Router

Figure 4-1
figure shows the front panel of the router.
Figure 4-1
1
3
To install a Cisco Secure Router 520 Ethernet-to-Ethernet router, follow these steps:
If you have a wireless router, first connect the radio antenna to the router. See the
Step 1
Antenna to a Wireless Router" section on page
Connect the server, PC, or workstation to the router. See the
Step 2
section on page
(Optional) If you need to connect more than four PCs, connect an external Ethernet switch to the router's
Step 3
built-in switch. See the
Connect a broadband modem to the router for Internet connection. See the
Step 4
Modem" section on page
Cisco Secure Router 520 Series Hardware Installation Guide
4-2
shows a typical installation for the Cisco Secure Router 520 Ethernet-to-Ethernet router. The
Typical Installation of a Cisco Secure Router 520 Ethernet-to-Ethernet Router
1
1X
2X
1X
2X
1
Ethernet connection to an external switch
WAN connection to the Internet using a
broadband modem
4-6.
"Connecting an External Ethernet Switch (Optional)" section on page
4-8.
3
2
Internet Internet Internet
2 Ethernet connection to a PC
4
Console port
3-1.
"Connecting a Server, PC, or Workstation"
Chapter 4 Router Installation
Cisco Secure Router 500 Series
4
"Connecting a Radio
4-7.
"Connecting a Broadband
OL-12892-01