Advertisement
2. Press and hold the SET POINT button then
press and hold the PRINCE CASTLE button for 6
seconds. The LED indicator next to PROG will
light to indicate the Program Mode is active.
3. Use the UP and DOWN arrow buttons to in-
crease or decrease the setpoint temperature.
4. Press the SET POINT button to end the Program
Mode and store the setpoint temperature value
(the LED next to PROG will turn off). The con-
troller will regulate to the new setpoint tempera-
ture.
5. Repeat Steps 1-4 for remaining heaters.
Programming Timers
1. Press and hold the PROG button for 6 seconds.
All six timer displays will change to show Prog.
545-502revB
2. Press the timer button to change. The timer
button LED will change to yellow and the current
programmed time is displayed.
3. Press the UP or DOWN arrow buttons to set the
time. Time values below 60 minutes will cause
the M:S led to light, and time values equal to or
greater than one hour will cause the H:M led to
light.
4. Repeat steps 2 and 3 for other timers. Press the
PROG button to store the new values and end
the Program Mode.
3
Printed in USA 1/06 © 2006
Advertisement
