Table of Contents
Advertisement
2. PREPARE THE INSTALLATION
Remove the installation kit from inside the hood.
M ake sure the following items are included:
-Filters
-Halogen lights (120V, 50W, PAR 20)
-Wood mounting strip
-Bag of parts including:
(1) Wire clamp, (2) Wire connectors, (2) Wall
anchors, (4) #10-2" countersunk head screws,
(6) #8-3/4 screws, (10) #8-3/8" screws,
(4) Locknuts, (2) Washers 3/16" ID x ¾" OK
Using a Phillips #2 or a Robertson #2 screwdriver,
unscrew the hood from the bottom of crate. Refer to
figure below to locate all screws (fig A). discard the
screws and remove hood from wood pallet.
Parts sold separately:
-Heat lamps (120V, IR 175W, PAR 38)
-Backsplash (optional)
-Duct (optional)
Install the adaptor:
A)
Slide the adapter tab in its notch, onexterior side of the rought-in plate.
B)
Using two (2) #8-3/8" screws, secure the adapter to the top of the hood.
C) Seal the adapter to the hood using duct tape.
Residential Wall Mount Hood
(fig A)
5
1
2
4
3
8
Hide quick links:
Advertisement
Table of Contents
