Table of Contents
Advertisement
CAUTION IN SERVICING
Initializing This Unit
Make sure to initialize this unit after replacing the microcomputer or any peripheral equipment, or the digital PCB.
1.
Press the power operation button " X " to turn off the power, and remove the AC plug from the socket.
2.
Insert the AC plug into the socket while pressing and holding the "WPS" and "iOS" buttons on the rear panel.
(Factory Reset)
3.
Press the power operation button " X " to turn off the power, and remove the AC plug from the socket.
4.
Insert the AC plug while pressing the power operation button" X ". (Starts in Special mode.)
5.
Press the "CURSOR d " button, and press the "Enter" button on the "Initialize" display.
(Initialized)
6.
Wait for more than 90 seconds after "Initialized" is displayed and then turn the power off.
(During this time, start and initialize the network devices.)
NOTE：
• If the unit fails to enter the service mode in step 6, repeat the procedure from step 1.
• Initializing the device restores the customized settings to the factory settings. Write down your settings in advance and
reconfigure the settings after initialization.
X
CURSOR
WPS
iOS
11
Advertisement
Table of Contents
