Updating Via Dpms - Denon DRA-100 Service Manual

2. Updating via DPMS

Download the latest firmware from our website and update the firmware.
2.1. Network Connection
(1) System Requirements
• Internet Connection by Broadband Circuit
• Modem
• Router
• Ethernet cable (CAT-5 or greater is recommended)
(2) Setting
インターネッ ト
モデム
WAN側へ
ルータ
LANポートヘ
LANポートヘ
2.2. Check and update the firmware
Check if there is a firmware update available. It is also possible to check approximately how long the update will take.
(1) Press the " X " button to turn on the power button.
(2) "Press "INPUT" and "Cursor 0 / 1 " buttons to select "Setup". Press "ENTER" button.
• Press "Cursor d / f " buttons to select "General". Press "ENTER" button.
• Press "Cursor d / f " buttons to select "Firmware". Press "ENTER" button.
• Press "Cursor d / f " buttons to select "Update". Press "ENTER" button.
• Press "Cursor d / f " buttons to select "Check for Update".
(3) Press the "ENTER" button.
• "Connecting..." is displayed and the unit connects to a DPMS server.
• "New firmware is available" is displayed when there is new firmware that can be updated on the server.
There is no need to update when "Latest Firmware" is displayed.
(4) Press the "ENTER" button, select "YES" and press the "ENTER" button again.
(5) The firmware update will be initiated.
---Cautions on Firmware Update---
• For the update procedure, a proper broadband Internet connection environment and settings are required.
• Do not turn off the power until updating is completed.
• It takes around 0.5 hour to complete the update.
Once an update is started, normal operations cannot be performed until it is completed.
Also, setting items may be initialized.
Note down the settings before updating, and set them again after updating.
パソコン
LANポート/Ethernet端子
28
本機のETHERNET端子