Table of Contents
Advertisement
Mounting and connection
4.6 Connecting a programming device
The carrier controller features an RJ45 interface for connection of a programming device.
Requirement
● The EMS carrier is connected to the power supply
● The EMS carrier is mounted to the EMS
● 1 shielded data cable
Note
You will risk malfunctions if using data cables that are not approved. Always use shielded
standard cables for data transmission.
Approved data cables are listed at:
Industry Mall (http://mall.automation.siemens.com)
Procedure
For information about the connection of a programming and procedures for data
transmission, refer to the "S7-1200 Automation System" system manual
(http://support.automation.siemens.com/WW/view/de/36932465/0/en).
28
Operating Instructions, 09/2013, A5E03474162-02
Carrier controller
Advertisement
Table of Contents
