Fimap ENJOY 360 Adjustments

Adjustments And Inspections
READ THE OPERATING AND MAINTENANCE MANUAL

Testing the Electric System

1. Remove the battery connector.
2. Check that the battery connection cables are clean
and tight.
3. Check that the power cables are connected and
tight: batteries,
switches (both in the electric system box and in the
suction head), motors etc.
4. Check the state of the
 Main 3,5 A
 Suction 20 A
 Brushes 25 A
 Traction 60 A
5. Reconnect the battery connector.
6. Turn the key to turn the machine on.
7. Check signal lamps and switches:
 Check that the key operates correctly;
 Check that the hour meter operates correctly;
 Check that the start control switch operates
correctly: forward and reverse;
 Check that the battery monitoring LEDs operate
correctly;
 Check that the horn operates correctly;
 Check that
correctly;
 Check that the reverse buzzer operates correctly.
Attention : if you use
GEL BATTERIES, on the
internal side of the check
batteries remove the
jumper located under
the protection
ADJUSTMENTS AND
INSPECTIONS
connectors, remote
thermal fuses:
the seat microswitch
ENJOY 360
control
operates
Doc. 10005053
Issued 12/2006
Rev. 00
Page 1 of 8